Publication: Heat transfer and thermal stresses in a circular tube with a non-uniform heat flux
dc.affiliation.dpto | UC3M. Departamento de Ingeniería Térmica y de Fluidos | es |
dc.affiliation.grupoinv | UC3M. Grupo de Investigación: Ingeniería de Sistemas Energéticos | es |
dc.contributor.author | Marugán Cruz, Carolina | |
dc.contributor.author | Flores Arias, Óscar | |
dc.contributor.author | Santana Santana, Domingo José | |
dc.contributor.author | García-Villalba Navaridas, Manuel | |
dc.contributor.funder | Ministerio de Economía y Competitividad (España) | es |
dc.date.accessioned | 2021-03-02T15:12:32Z | |
dc.date.available | 2021-03-02T15:12:32Z | |
dc.date.issued | 2016-05-01 | |
dc.description.abstract | This paper presents a thermal analysis of thin-wall pipes under non-uniform heat flux in the circumferential direction, with a turbulent flow in statistically stationary state inside. The temperature distribution in the solid and in the fluid is obtained using an spectral method that solves the conjugate heat transfer problem. Special attention is paid to the inner wall fluid temperatures and the thermal stresses on the solid, that are compared to predictions based on 1D models in which the circumferential heat transfer is neglected. The comparison shows that, even if at sufficiently large Biot numbers (Bi greater than or similar to 0.3) the 1D model gives a reasonable prediction of the inner wall fluid temperatures (less than 5% of error), the 1D model for the thermal stresses is only appropriate for very large Biot numbers (Bi greater than or similar to 10), giving qualitatively wrong results for Biot numbers below 0.3. (C) 2016 Elsevier Ltd. All rights reserved. | en |
dc.description.sponsorship | This work was supported by the Spanish Ministry of Economy and Competitiveness through the Grant ENE2012-34255. O.F. and M.G.-V. were partially supported by Grant TRA2013-41103-P of the Spanish Ministry of Economy and Competitiveness. The latter grant includes FEDER funding | en |
dc.identifier.bibliographicCitation | Marugán-Cruz, C., Flores, O., Santana, D., & García-Villalba, M. (2016). Heat transfer and thermal stresses in a circular tube with a non-uniform heat flux. International Journal of Heat and Mass Transfer, 96, 256-266 | |
dc.identifier.doi | https://doi.org/10.1016/j.ijheatmasstransfer.2016.01.035 | |
dc.identifier.issn | 0017-9310 | |
dc.identifier.publicationfirstpage | 256 | |
dc.identifier.publicationlastpage | 266 | |
dc.identifier.publicationtitle | International Journal of Heat and Mass Transfer | |
dc.identifier.publicationvolume | 96 | |
dc.identifier.uri | https://hdl.handle.net/10016/32068 | |
dc.identifier.uxxi | AR/0000017814 | |
dc.language.iso | eng | |
dc.publisher | Elsevier | |
dc.relation.projectID | Gobierno de España. ENE2012-34255 | |
dc.relation.projectID | Gobierno de España. TRA2013-41103-P | |
dc.rights | © 2016 Elsevier | |
dc.rights | Atribución-NoComercial-SinDerivadas 3.0 España | |
dc.rights.accessRights | open access | |
dc.rights.uri | http://creativecommons.org/licenses/by-nc-nd/3.0/es/ | |
dc.subject.eciencia | Ingeniería Industrial | es |
dc.subject.other | Temperature distribution | en |
dc.subject.other | Thermal stress | en |
dc.subject.other | Non-uniform heat flux | en |
dc.subject.other | Biot number | en |
dc.subject.other | Direct numerical simulation | en |
dc.subject.other | Varying inlet temperature | en |
dc.subject.other | Forced convection | en |
dc.subject.other | Boundary conditions | en |
dc.subject.other | Turbulent pipe | en |
dc.subject.other | Channel flow | en |
dc.subject.other | Receiver | en |
dc.subject.other | Ducts | en |
dc.subject.other | Mass | en |
dc.title | Heat transfer and thermal stresses in a circular tube with a non-uniform heat flux | en |
dc.type | research article | * |
dc.type.hasVersion | AM | * |
dspace.entity.type | Publication |
Files
Original bundle
1 - 1 of 1