Marugán Cruz, CarolinaFlores Arias, ÓscarSantana Santana, Domingo JoséGarcía-Villalba Navaridas, Manuel2021-03-022021-03-022016-05-01Marugán-Cruz, C., Flores, O., Santana, D., & García-Villalba, M. (2016). Heat transfer and thermal stresses in a circular tube with a non-uniform heat flux. International Journal of Heat and Mass Transfer, 96, 256-2660017-9310https://hdl.handle.net/10016/32068This paper presents a thermal analysis of thin-wall pipes under non-uniform heat flux in the circumferential direction, with a turbulent flow in statistically stationary state inside. The temperature distribution in the solid and in the fluid is obtained using an spectral method that solves the conjugate heat transfer problem. Special attention is paid to the inner wall fluid temperatures and the thermal stresses on the solid, that are compared to predictions based on 1D models in which the circumferential heat transfer is neglected. The comparison shows that, even if at sufficiently large Biot numbers (Bi greater than or similar to 0.3) the 1D model gives a reasonable prediction of the inner wall fluid temperatures (less than 5% of error), the 1D model for the thermal stresses is only appropriate for very large Biot numbers (Bi greater than or similar to 10), giving qualitatively wrong results for Biot numbers below 0.3. (C) 2016 Elsevier Ltd. All rights reserved.eng© 2016 ElsevierAtribución-NoComercial-SinDerivadas 3.0 EspañaTemperature distributionThermal stressNon-uniform heat fluxBiot numberDirect numerical simulationVarying inlet temperatureForced convectionBoundary conditionsTurbulent pipeChannel flowReceiverDuctsMassresearch articleIngeniería Industrialhttps://doi.org/10.1016/j.ijheatmasstransfer.2016.01.035open access256266International Journal of Heat and Mass Transfer96AR/0000017814