Nicolás Morillas, María deBesharatloo, H.Wheeler, J. M.Dios Pérez, Miguel deAlvaredo Olmos, PaulaRoa, J. J.Ferrari, B.Llanes, L.Gordo Odériz, Elena2022-01-192022-02-012020-02de Nicolás, M., Besharatloo, H., Wheeler, J., de Dios, M., Alvaredo, P., Roa, J., Ferrari, B., Llanes, L. & Gordo, E. (2020). Influence of the processing route on the properties of Ti(C,N)-Fe15Ni cermets. International Journal of Refractory Metals and Hard Materials, 87, 105046.0263-4368https://hdl.handle.net/10016/33910This study aims to understand the influence of powder preparation and processing steps on the microstructure and properties of Ti(C,N)-Fe15Ni cermets with 70 and 80 vol% of ceramic phase. Two routes were used for powder preparation: (i) a colloidal approach, consisting of the preparation of stable aqueous suspensions of the powder particles and spray-drying to obtain easy-to-press granules, and (ii) conventional powder metallurgy route, consisting on wet ball milling of powders, with subsequent drying in rotary evaporator. The resultant powder mixtures were uniaxially pressed and sintered in high-vacuum at 1450 °C for 2 h. Sintered samples were characterized in terms of their density, porosity, microstructure (FESEM, image analysis), composition (EDX and XRD), small-scale hardness and sliding contact response by means of massive nanoindentation and nanoscratch testing. C content of the mixture powders was lower for conventional route, lost during milling. After sintering, all the materials, despite the processing route and composition, show C reduction, although that outflow is higher for the conventional powder metallurgy route, and more evident for the composition with higher binder content. As a result, COL samples exhibit a more homogeneous microstructural assemblage, higher small-scale hardness and mechanical integrity under sliding contact conditions. Compositions of materials must then be adjusted to adequate initial C addition with respect to the employed processing route, to account for the effects of the mixtures preparation stage.9eng© 2019 Elsevier Ltd. All rights reserved.Atribución-NoComercial-SinDerivadas 3.0 EspañaBall millingCermetsColloidalMassive nanoindentationNanoscratchProcessing routeresearch articleIngeniería IndustrialMaterialesQuímicahttps://doi.org/10.1016/j.ijrmhm.2019.105046open access11050469International Journal of Refractory Metals and Hard Materials87AR/0000025561