Encinas García, NoemíAbenojar Buendía, JuanaMartínez Casanova, Miguel Ángel2016-05-242016-05-242012-03International journal of adhesion & adhesives 33 (2012), pp. 1-60143-7496http://hdl.handle.net/10016/23082The present work deals with the problematic adhesive bonding of substrates with low surface energy. Different approaches have been explored with the aim of creating adequate adhesive joints based on polyolefinic substrate and polyurethane adhesive. The selected material under study was polypropylene (PP) as adherend, and a commercial Sikaflex®-252 polyurethane one component based structural adhesive (PU) as joint fluid. Among the diverse pre-treatments typically used to prepare surfaces prior to bonding, mechanical abrasion with emery paper of 80 grain size, the use of a chemical primer and atmospheric pressure air plasma torch (APPT) were the selected methods to facilitate the application of the PU by means of surface energy enhancement as well as to create a correct mechanical interlocking of the adherent-adhesive interface. Changes in the wettability of the polymer were evaluated by contact angle measurements following the UNE EN 828:2010. Surface energy was calculated both in terms of Owens approximation and acid-base considerations, leading to the possibility of determining a relationship between changes in surface energy and adhesion. Changes in the chemical composition of the surface were studied by X-ray photoelectron spectroscopy (XPS), electron diffraction X-Ray (EDX) probe and attenuated total multiple reflection mode infrared spectroscopy (ATR-FTIR). Morphological modifications were investigated with scanning electron microscopy (SEM). Variations in the strength of single-lap PP-PP joints with the treatments were evaluated by lap shear tests following the UNE-EN 1465:2008 standard. Experimental evidence supports the superiority of the APPT treatment to increase wettability and adhesion of polyolefinic surfaces, especially when combined with the use of a primer.6application/pdfeng© 2011 Elsevier Ltd.Atribución-NoComercial-SinDerivadas 3.0 EspañaPolymeric surface preparationWettabilityLewis acid and baseWork of adhesionAtmospheric pressure plasma torchPrimerPolyurethanePolypropyleneAdhesionresearch articleMateriales10.1016/j.ijadhadh.2011.10.002open access16International journal of adhesion & adhesives33AR/0000009727