|
Archivo Abierto Institucional de la Universidad Carlos III de Madrid >
Investigación >
Departamentos >
Departamento de Ingeniería Mecánica >
FabDis. Grupo de Tecnologías de Fabricación y Diseño de Componentes Mecánicos y Biomecánicos >
DIM - FABDIS - Artículos de revistas >
Please use this identifier to cite or link to this item:
http://hdl.handle.net/10016/15403
|
| Title: | Cutting performance of TiCN–HSS cermet in dry machining |
| Author(s): | Canteli Fernández, José Antonio
Cantero Guisández, José Luis
Marín, N.C.
Gómez, B.
Gordo Odériz, Elena
Miguélez, Henar |
| Publisher: | Elsevier |
| Issued date: | 1-Jan-2010 |
| Citation: | Journal of Materials Processing Technology, 210(1), 2010, 122-128 |
| URI: | http://hdl.handle.net/10016/15403 |
| ISSN: | 0924-0136 |
| DOI: | 10.1016/j.jmatprotec.2009.08.003 |
| Abstract: | This work is focused on the cutting performance of a new cermet based on high-speed steel (HSS) matrix with hard phase TiCN. The processing route to manufacture the cermet M2+ 50 vol.% TiCN is described. Orthogonal cutting tests, carried out in a lathe showed the ability of the new cermet to achieve turning operations, showing reasonably wear resistance performing dry cutting operations. Tool life was significantly increased, when the cermet was compared with the reference material M2 without reinforcement and with commercial HSS M2. Evolution of flank wear and chipping wear, being the dominant wear patterns, were analysed. |
| Sponsor: | The authors acknowledge financial support to the Ministry of Education and Science of Spain (Project DPI2005-08018). |
| Publisher version: | http://dx.doi.org/10.1016/j.jmatprotec.2009.08.003 |
| Keywords: | New cutting material
Cermets
HSS–TiCN
Wear |
| Rights: | © Elsevier |
| Appears in Collections: | DIM - FABDIS - Artículos de revistas
|
Items in E-Archivo are protected by copyright, with all rights reserved, unless otherwise indicated.
|
